Matrix Games Forums

I wrote this report on the wrong forum:
https://www.matrixgames.com/forums/view ... 7&t=394072

But I think I figured out the issue:
The quality settings did not properly translate to the subunits!
They were still on all Allowed, not low Tolerated.


It could have been because they weren't attached all the time. Meaning that attaching them does not propagate the value from the OHQ properly.

But that is a problem - they aren't on Unit TOE side of the Model Management. Meaning I am relying on the OHQ settings to be applied.

Okay, setting the value on the Attached Units directly got it seemingly reset on end turn.

I had to set the value on the OHQ again, for it to properly work.