Page 1 of 1

tiger on the hunt

Posted: Sat Jun 22, 2024 9:00 am
by fran52
When is possible to have upload and unload of units and guns?

Re: tiger on the hunt

Posted: Sun Jun 23, 2024 7:09 pm
by Peter Fisla
Sorry fran52, I'm not 100% sure I understand your question. Are you asking if a unit can un-poses an ordnance? Or are asking about TotH graphics file?

If it's first...then I'm not sure to be honest with you. I believe the game is complete, in terms of want I wanted to achieve from this project. I'm not going to say no....because right now I don't have any further plans to work on project...but you never know ;)

Re: tiger on the hunt

Posted: Fri Sep 27, 2024 5:23 am
by fran52
I mean load unload from a truck for example.

Re: tiger on the hunt

Posted: Fri Sep 27, 2024 5:25 am
by fran52
Another thing not understood.When there is the pre-game setup,in which way is possible to setup the units?

Re: tiger on the hunt

Posted: Fri Sep 27, 2024 3:47 pm
by Peter Fisla
If at all or what units will be available for setup is determined by a scenario designer.

I hope that helps...

Re: tiger on the hunt

Posted: Sat Sep 28, 2024 5:08 am
by fran52
Ok but when is possible which procedure must be performed?i'm not able to find the procedure into the instruction.
And about the load unload there is something in project? load unload of units and also gun,

Re: tiger on the hunt

Posted: Sat Sep 28, 2024 4:40 pm
by Peter Fisla
Hi fran52,

As I mentioned earlier, the game doesn't support loading and un-loading ordnance, infantry on half-tracks etc. This functionality is not in the game.

Re: tiger on the hunt

Posted: Sun Sep 29, 2024 5:34 am
by fran52
Peter is not an answer.I know that load unload is not supported but i asked if there is something in project for the future.
And about the procedure of the pregame setup I know as much as before.

Re: tiger on the hunt

Posted: Sun Sep 29, 2024 7:30 am
by Paullus
Fran52,

Loading and unloading is not an option and it is not in the project at the moment.

Regarding Pre-game Setup you'll find the instructions in the manual chapter 8.1.12

I hope it helps