Matrix Games Forums

Hi Guys and Girls,

I am currently doing an air warfare tutorial that has 3 missions going. A patrol and 2 strike missions. So I have a recon aircraft in one and 3 pairs of fighters in the remaining missions. On the map I can see all my fighters but I must be getting blind as I cannot locate the recon aircraft. In the side bar on the right of screen (after highlighting it in the mission editor) it shows my "missing" aircraft doing 200 knots groundspeed. Is there a key combo that would enable me to highlight a particular aircraft on my map?

Much obliged.

Peter

Please always post a scenario file so that we can help you, without it, it is often impossible to help.

To do this create a .zip of the .save created when you save a scenario and upload it using the forum attachment tool.

Not in a position to post a save but I found one of my scenarios all the aircraft had vanished to nearly the opposite side of the planet... Or at least so far away they weren't going to get back to base... Strange anomoly but work got in the way of further investigation and a Tech post.

Try the OOB from the drop down and see if your aircraft are present, double click will take you to them?

Only a thought.
K

Thanks,
Yes that was the info I was after. Will give the Order of Battle menu a go.

Cheers

Peter

Well the reason I could not see the aircraft was it was still on the ground. Now to figure out why it did not take off after I started the scenario. I didnt do anything different compared to the other aircraft that I am aware of and they definitely took off.
Will run the scenario again and see if I can spot the obvious.

Cheers

PC