Page 1 of 1
[FIXED] Auto RTB after take-off (?)
Posted: Sat Apr 12, 2025 4:44 pm
by Knightpawn
Any theory why F/A-18C VFA-136 "Knighthawks 6" (and only this plane amongst all with the particular loadout) goes RTB immediately after take-off (regardless if solo, as part of a group, or part of a strike mission). I am totally baffled
PS: the plan is on board JFK Carrier
Re: Auto RTB after take-off (?)
Posted: Sat Apr 12, 2025 5:19 pm
by Uzabit
Since the plane is assigned to the JFK task pool without a specific mission, did you launch the plane individually from the air operations menu? I also get an RTB with Knighthawks #10 without an assigned mission within the task pool.
RTB on #10

- Knighthawks 10.png (511.15 KiB) Viewed 456 times
I unassigned Knighthawks #6 from JFK task pool, resulting in a reversing of the RTB command:

- Knighthawks 6.png (516.64 KiB) Viewed 456 times
Re: Auto RTB after take-off (?)
Posted: Sat Apr 12, 2025 5:23 pm
by Uzabit
Also, the "Strike mission" within the task pool is an air intercept mission setup that will be problematic with that loadout.
Re: Auto RTB after take-off (?)
Posted: Sat Apr 12, 2025 6:01 pm
by Knightpawn
It RTBs in all the following variations:
Launched individually
Launched as part of a group
Launched as part of a strike mission
That particular plane only. I cannot explain the behavior
Re: Auto RTB after take-off (?)
Posted: Sat Apr 12, 2025 6:59 pm
by Uzabit
Ah — okay. It seems to be an issue with the specific unit ID within the scenario, which a developer might want to investigate—perhaps an incompatibility with an older build version in which the scenario was created. I removed the unit and replaced it with one of the same name in the editor. The only difference is that the unit is currently parked in the hangar, but the issue hasn't occurred again.
Re: Auto RTB after take-off (?)
Posted: Sun Apr 13, 2025 5:13 am
by Knightpawn
Uzabit wrote: Sat Apr 12, 2025 6:59 pm
Ah — okay. It seems to be an issue with the specific unit ID within the scenario, which a developer might want to investigate—perhaps an incompatibility with an older build version in which the scenario was created. I removed the unit and replaced it with one of the same name in the editor. The only difference is that the unit is currently parked in the hangar, but the issue hasn't occurred again.
Thanks!
Re: Auto RTB after take-off (?)
Posted: Tue Apr 15, 2025 7:39 am
by blu3s
Thanks for the report
Logged 0016651
Re: Auto RTB after take-off (?)
Posted: Thu May 08, 2025 6:34 am
by Phazon
I have been playing the Command public beta 1.08 build 1638 on steam.
I have been encountering this issue at times playing through some of the tutorial missions. Easiest mission for reproduction is Strike Tutorial 1. The F-16's will be commanded to RTB not long after take-off.
I would also get this issue sometimes on Surface Warfare 5 with the 2 embarked helicopters.
I don't remember getting this issue playing through the Flight tutorials 1-8 however.
Re: Auto RTB after take-off (?)
Posted: Thu May 08, 2025 8:32 pm
by Dimitris
This should be fixed for the next update.