Can't Select Detected Unit
Posted: Tue Apr 07, 2026 4:36 pm
Good Afternoon
Build: 1825.15 (Steam)
Scenario: Desert Storm (DLC) - Invasion
I am unable to select an enemy unit that has ambiguity to see what it has been detected by, but if i drag a box around it with the mouse it will select and show detections in the right hand panel.
To see it happen just launch scenario run for a short while till the mission launch, then wait for MOBILE #2408 (located north of Iraq near Mosul AB) to display after been picked picked up by Bogey #1 and try cick on the unit to see contact status. It will be unselectable, then just drag a box around it with the mouse at which point it will select and display contact status. It will still not be selectable after this.
I don't know if it applies to units without ambiguity as the other unit were detected by allies rather than my own units.
Save and Recent Logs.
Thanks for your time.
Build: 1825.15 (Steam)
Scenario: Desert Storm (DLC) - Invasion
I am unable to select an enemy unit that has ambiguity to see what it has been detected by, but if i drag a box around it with the mouse it will select and show detections in the right hand panel.
To see it happen just launch scenario run for a short while till the mission launch, then wait for MOBILE #2408 (located north of Iraq near Mosul AB) to display after been picked picked up by Bogey #1 and try cick on the unit to see contact status. It will be unselectable, then just drag a box around it with the mouse at which point it will select and display contact status. It will still not be selectable after this.
I don't know if it applies to units without ambiguity as the other unit were detected by allies rather than my own units.
Save and Recent Logs.
Thanks for your time.