Page 1 of 1
Generated Campaign Problem
Posted: Thu Feb 15, 2001 7:34 pm
by Warhorse
Has anyone else experienced a crash to desktop at the completion of a battle with a campaign made by the Generater, in this case Comm China in '45? It didn't even get to the refit screen, went to the results screen, hit done, then crashed!! Last time it went to the next battle, which switched to Germans, in what appeared to be WB's one campaign, not sure which!!! I think this generater must have problems with nations other than the big 6? Anyone else???
------------------
Mike Amos
Meine Ehre Heisst Treue
Posted: Fri Feb 16, 2001 1:56 am
by Warhorse
Bump
------------------
Mike Amos
Meine Ehre Heisst Treue
Posted: Fri Feb 16, 2001 2:14 am
by Sgt. Rick
I have had similar problems, but it occurs on WWII campaign during game play. It has occurred on every version so far. In most cases it occurs on the computer's turn.
I usually end up getting rid of the .prf file.
Posted: Fri Feb 16, 2001 12:48 pm
by Igor
Well, yes and no. The basic game is woefully unprepared for a PLA campaign; I'm slogging through one right now (1930-1949; now there's a tour of duty!), and every single battle has been in Central Europe.
If you play the game completely clean; no editting of any kind to make it more interesting (or realistic), then the campaign engine works. Otherwise, it crashes and burns. For me, it was a "pick a front" screen with a French flag on the lower left hand corner with only Europe as a possibility (and of course, no provision made for Chinese in the ETO).
I have no real hopes that the nice folks will ever enable a more realistic Chinese campaign by coming up with battle locations and such like; but still, it would be nice. Especially when you consider that there isn't any other point to the game being playable in 1930; only the Chinese were fighting then, after all. Ah, well. Perhaps one of these versions or other.