Page 1 of 1
Fighter missions (commanding CV)
Posted: Fri Jul 23, 2004 3:13 pm
by Mr.Frag
I am a little baffled here.
I send a group of 2 fighters to attack a minefield. They fly out, the first fighter unloads on one of the mines in the selected target group then every group does an RTB without firing a shot. The second fighter never engages. It's like the target is ONLY 1 specific mine, not the collection of mines that make up the field.
Once they start the RTB, I can't seem to get them to turn around and get back into the action no matter what I order.
RE: Fighter missions (commanding CV)
Posted: Fri Jul 23, 2004 5:36 pm
by Mehrunes
What type of mission are you sending them out on? Sweep? Strike?
RE: Fighter missions (commanding CV)
Posted: Fri Jul 23, 2004 5:47 pm
by Black Cat
It your subconscious at work Frag, you know your supposed to be working on the WITP Patch[:D]
RE: Fighter missions (commanding CV)
Posted: Fri Jul 23, 2004 5:55 pm
by Mr.Frag
What type of mission are you sending them out on? Sweep? Strike?
I scout them out until located then use the package assault combo.
RE: Fighter missions (commanding CV)
Posted: Fri Jul 23, 2004 6:02 pm
by John DiCamillo
This is a side effect of a much-requested fix: Radio commands are now ship-specific instead of element-specific. Remember back when you were a fighter pilot destroying mines the hard way? And you told your wingman to target a specific mine? This works the same way when you are commanding a carrier.
RE: Fighter missions (commanding CV)
Posted: Fri Jul 23, 2004 6:28 pm
by Mr.Frag
And you told your wingman to target a specific mine? This works the same way when you are commanding a carrier.
Ok, so all targets are single in nature even though it may be part of a larger group?
So sending the mission to strike minefield a actually translates to strike a specific mine in group a.
Hows this work with going after a wave of incoming fighters? Will my 4 intercepters do a RTB after shooting down the first guy?
Not sure what you mean Radio fix. I still can't order any units about #9 (which generally is most of my fighters) [:D]
RE: Fighter missions (commanding CV)
Posted: Fri Jul 23, 2004 9:45 pm
by TheDeadlyShoe
Wellt he problem for examples was that if you targeted a frigate on an incoming fighter wing it would target the "group" which always meant the first fighter and work its way down the chain. No matter how many groups of yours you targeted on the neemy, they would always target on 1 first and work their way down. This had many problems.
Try adjusting navpoints so that the fighters are Patrolling or Sweeping to a navpoint in the field
RE: Fighter missions (commanding CV)
Posted: Fri Jul 23, 2004 9:53 pm
by Count Sessine
A patrol nav point inside the field makes the ships engage all mines in the vicinity.