Page 1 of 1

INDEPENDENT Command

Posted: Mon Aug 16, 2004 2:16 pm
by zed
I flew my dauntless bombers from my carrier to Austrailia, then back onto the carrier after a few turns. I noticed the command says "Austrialia Command" instead of "Independent" like the other bombers and planes. I tried to change it but there is no "Independent" selection. What am I doing wrong?

RE: INDEPENDENT Command

Posted: Mon Aug 16, 2004 5:33 pm
by Toro
You want that to be something other than "independent." A squadron with no HQ cannot upgrade a/c, and I believe cannot receive replacements. In effect, your a/c "chopped" into the Oz Command when they arrived there. I believe you can chop into another HQ by visiting the port where another HQ is located.

BTW, a/c don't have to leave the CV to chop into a command; the CV can port-visit and see the same results.

RE: INDEPENDENT Command

Posted: Mon Aug 16, 2004 5:55 pm
by Mr.Frag
I flew my dauntless bombers from my carrier to Austrailia, then back onto the carrier after a few turns. I noticed the command says "Austrialia Command" instead of "Independent" like the other bombers and planes. I tried to change it but there is no "Independent" selection. What am I doing wrong?

Nothing you are doing wrong apart from flying them off the CV in the first place ... now you'll have to pay to transfer them to a non-restricted HQ. You can't get them back to Independant.

I assume you have some form of computer zone control running?