Page 1 of 1
How do I put a player in motion in coach mode
Posted: Sat Mar 04, 2006 11:52 am
by kzdwfy
I trying to practice a play but my player never goes in motion before the snap... Am I doing something wrong
RE: How do I put a player in motion in coach mode
Posted: Sat Mar 04, 2006 4:33 pm
by Paul Vebber
Use the 2 key (or button 2 on the controller) to run pre-snap motion.
RE: How do I put a player in motion in coach mode
Posted: Sat Mar 04, 2006 4:59 pm
by SlapBone
I think an accurate question is WHY do you have to put the player in motion in coach mode. If you call a play that has motion it should'nt be executed automatically? Do wide receivers in the CFL wait for a coach's cue to start in motion?
RE: How do I put a player in motion in coach mode
Posted: Sat Mar 04, 2006 6:33 pm
by Erik Rutins
SlapBone,
This forum is for support and help requests, not commentary. Thanks.
Regards,
- Erik
RE: How do I put a player in motion in coach mode
Posted: Sat Mar 04, 2006 6:39 pm
by Erik Rutins
I thought I should add to this David's reply from another thread:
"The presnap commands for coach are the same as arcade. Someone asked why they need to send the players in motion in coach mode. It's the same reason you need to snap the ball in coach mode. The most important reason is that it gives you, as a gamer, something to do on the field. Secondly, it allows you to decide wheather or not to put the players in motion. Just because a play is drawn up with motion, doesn't mean you care to do that.
To call a time out, press button (key) 3 while the players are going back to the huddle. "