Page 1 of 1
Lendlease Bug
Posted: Fri May 12, 2006 3:59 am
by Harrybanana
I've noticed this bug a few times but I can never duplicate it. The bug is that sometimes as the WA when I try to transport supply from England to Russia via a Murmansk type convoy not all of the supply will be transported. I know I have unused transport capacity, I'll try and transport 30 supply, but less than 30 will arrive; and I can't ship any more because my transport capacity has been reduced to 0. I'm not saying this happens all the time, but it happens enough to be frustrating. Most recently only 21 of 30 supply got shipped.
Has anyone else noticed this bug?
RE: Lendlease Bug
Posted: Fri May 12, 2006 6:43 am
by JanSorensen
Just to be clear.
Is this with v1200 or v1087?
Does it seem to happen only when moving a full stack of 30 - or does it seem to happen when moving smaller stacks as well? I know you cannot reproduce the bug reliably - so any information is good when trying to track it down.
RE: Lendlease Bug
Posted: Fri May 12, 2006 7:58 am
by Joel Billings
Had you already used 9 capacity somewhere in your transport chain before starting to ship to Russia. If using Auto Supply, often supply is shipped over transports without your knowing it.
RE: Lendlease Bug
Posted: Fri May 19, 2006 11:04 pm
by Harrybanana
Sorry Jan and Joel. I posted this bug a while ago and then got busy and forgot to check back in. I'm using 1.087. It has happened when I have attempted to move a lot of supply all at once, not always 30, but a lot. I haven't tried doing 1 supply at a time to see if that messes it up. I know I had all my transport capacity. I always use advanced supply with auto move off.
RE: Lendlease Bug
Posted: Fri May 19, 2006 11:21 pm
by JanSorensen
As I recall we did fix a bug in 1087 that could be causing this particular problem.