Sandbox enemy?

[kipanderson]

Hi,

clearly doing something very stupid but enemy seems to refuse to turn up. I "think.." I fill in/select all of options and
boxes correctly on the Single Player Sandbox launch screen but when I then play the scenario my forces are there OK but the
enemy doesn't seem to be around... its a no show by the bad guys [:D].

Obviously I am doing something wrong, seem to remember a similar problem in distant past with this series so
intuitively not getting it as I should.

Thanks for any suggestions..
Great series of games,
All the best,
kip.

[Biondo]

Hi Kip,

if you mean no enemy in the 3D world, probably you set battle type as Hunt Them Down. Probably they are on the opposite part of the map. Try to select Line of sight, the enemy will be 1000 yards in front of you ready to fight!

If you mean you don't see nothing on the 2D map, try a different setting in the options screen, page 1. You can change from All units visible to Bare Map where you only see your avatar's position.

I agree, great series

[kipanderson]

Biondo,

Thanks for the hints. Will do as you advise. Scourge of War deserves more time than I have given it so far.

Thanks again,
All the best,
Kip.

[Asid2]

Kip

If you need any assistance then pop over here

Regards

[kipanderson]

Asid,

once again am incredibly grateful. you run some fantastic sites [:)].

All the best,
kip.