Database Viewer Issues

[Radiorobot]

When using the 'Database viewer' and seemingly only while doing so the scroll bar increments by far too much. Instead of incrementing by 3 or so entries like in the 'Add new unit' window it increments by several dozen entries and in very odd increments at that. For example, if I scroll down from the top of the list by three increments it will always only require two increments to reach back to the top. Going further I found going 4 and 5 down only requires 3 up, 6 and 7 down requires 4 up, so on and so forth.

A current workaround for anyone else experiencing the issue is, after clicking a unit link, hover your mouse over the upper right portion of the window and tap either the up or down arrow key. It should jump to where your unit entry is on the list. Also just using the arrow keys tapped or held down to navigate the list makes it much easier without the jumpiness as it will scroll one entry at a time.

Additionally, when clicking on a unit link to open its database entry, for example when browsing through the 'Add new unit' window in the scenario editor, the Database Viewer will still highlight its entry as was normal in CMANO in the upper right part of the window. However, it is not scrolled to it on the list. Instead, it starts at the top of the list which when combined with the previous issue makes it very frustrating to browse many units quickly especially when searching for a particular variant of a unit with very many entries.

[Dimitris]

Hi,

if easy, can you please post each of these on its own thread, so that we can track and resolve them individually?

Thanks in advance!