[WAD] 127mm Gun Issue

[Primarchx]

I'm still seeing an issue where 127mm/54 cannon with HE-CVT, HE-PD and WP rounds do not reload their ready rounds from the magazine until all types of rounds are expended, even with one type specified for reload priority.

[michaelm75au]

From an earlier post:

When a mount is emptied the AI starts reloading it straight away. When half-empty, it waits 300 seconds (5 minutes) for the threat to clear and then starts reloading. Reloading leave your units vulnerable but so does a half-empty mount. The Command AI prefers to reload.

[Primarchx]

The mount is not half empty. When I'm shooting HE-PD there is the same amount of HE-CVT and a smaller amount of WP loaded as well. How does reloading a 5" naval gun leave it vulnerable? The rounds come from the magazine into the turret and get fired. Also if I shoot everything (ALL rounds in the mount), they all start to reload immediately.

[comsubpac]

Indeed, the reloading takes place under deck and shouldn't be an issue.

[ComDev]

It starts reloading half-empty mountd after 5 minutes to account for pop-up threats. In your setup, if you don't like this, I can suggest setting reload priority for only a single weapon type.

Thanks [8D]

[Primarchx]

I have load priority set up for HE-PD but nothing loads that round type once depleted until all rounds (the HE-CVT and WP) are exhausted, too. Then everything loads. Instead I have to fire my CVT rounds (I assume those are proximity fused frag rounds?) and WP to get any more HE back.

Not sure what the 5 minute wait is for if you're engaging a target and need more ammo to finish the job. Are you not able to fire the other round types while the HE-PD is being replenished?