Want to change at start leaders

[Kel]

I want to edit the 06/22/41 scenario setup and more specifically reorganize the at start leaders, but am not able to do so without spending admin points, and thus, is limited (we are in the editor, not in game) to firing 2-3 leaders and then stop.

Is it possible to edit leaders in the editor easily without spending admin points?

Thanks a lot

[Helpless]

Yes. Go to the unit tab and click on the leader link under HQ name, then select leader.

[Kel]

thanks a lot for your answer.

However, it is not very practical since you can not preview the values of the new leader while you allocate it. basically you can only choose a leader ID number. It seems a bit harsh (or you should have a printed list with all the leaders value to check at the same time)..

Another question, by the way, also concerning the 06/22 campaign scenario setup : what is the way to edit the support assets allocated to an HQ? I mean putting all the assets of HQs back to the pool and them reallocating them, on a more rationale basis to the HQs ?

k

[Helpless]

However, it is not very practical since you can not preview the values of the new leader while you allocate it. basically you can only choose a leader ID number. It seems a bit harsh (or you should have a printed list with all the leaders value to check at the same time)..

Primary goal of editor was to provide tool to build OOB and not optimize the setup. So in 99% name and current assignment is enough. Anyway, there are plans to improve selection screens in editor to provide more info. Also we will fix onmap function, so no more AP will be used. Currently you can go to the main tab and add large number of AP. Then change leader on map. After that restore AP.

Another question, by the way, also concerning the 06/22 campaign scenario setup : what is the way to edit the support assets allocated to an HQ? I mean putting all the assets of HQs back to the pool and them reallocating them, on a more rationale basis to the HQs ?

There is no pool for the support units. You should set them new HHQ.