Thank you! That explains it. I replaced with #169 as you said and it works now!

michaelm75au wrote: Mon Jun 12, 2023 8:26 am BTW, the BTR-80 in the attached has no signatures so that not being picked up by 'radar'.

Thank you! That explains it. I replaced with #169 as you said and it works now!

michaelm75au wrote: Mon Jun 12, 2023 4:17 am However, I have made it so if you click on the sensor, it will display the DB and highlight the appropriate loadout for now.

Thanks for the response! I did not understand this part though.

Hi there.
When I click the device in the detections of a contact, it does not show the database viewer.

Steps:
1. Open the scenario, set timebase and play.
2. When the contacts show up, click any of the contacts.
3. Go to the detections and click any link in the contacts.

The DB viewer is not ...

Hi.
I must be doing something wrong.

I created a simple scenario for testing strikes with the F/A 18C. Basically I added 5 BTR-80 (#171) on Syria Region. I launch some F18s flying as low as they can go, right over the targets and they simply won't be detected. Tried to add a U2 and that won't ...

Hi.
I played the scenario a few times and for some reason aircraft won't takeoff when I assign them to active strike mission.

Steps:
1. Launch manually the Meteor and make it find the first Artillery Bty (south side)
2. Create Land Strike mission with only selected target as the Artillery Bty.
3 ...

Hello... on the note below:


Spoiler:
You can just cruise in to about one convergence zone from the launch point, then slow down to about 10 kts and stay around the layer.

How should I measure one convergence zone from the launch point if the location says "no CZ"? Are you assuming a ...

<t> Hi All.<br/>
<br/>
I am looking for some help with this training scenario on Electronic Warfare. I'm sure its just a newbie mistake, but I just can't figure it out. <br/>
<br/>
In the state of this scenario, I should be able to fly the F-16l armed with the HARM and use that to kills the SAMS ...