Bolted Panel

This forum is for official support and troubleshooting FAQs.

Moderators: JAMiAM, ralphtricky

Post Reply
User avatar
MarcA
Posts: 1181
Joined: Wed Mar 02, 2005 12:04 pm
Location: England

Bolted Panel

Post by MarcA »

I play TOAW on two computers. On one the screen is of sufficient size to see the picture and stars in the bolted plate below the control panel. When I mouse over this I can see the information about percentage of turn used in the Information Panel.

On my other computer the screen is too small to show the picture and stars in the bolted panel, though the panel itself is there. When I mouse over this bolted panel I don't get any information in the Information Panel. Is there another way of seeing the proportion of turn left in the game without using the bolted panel?

Is there anyway to fix the actual mouse over problem itself?

Image
Legun
Posts: 209
Joined: Sat Apr 22, 2006 1:15 am
Location: Cracow, Poland

RE: Bolted Panel

Post by Legun »

try to hide control panel - it works for 1024*768 screen
Ralph - please, give my the composite units!
http://www.tdg.nu/cgi-bin/yabb2/YaBB.pl?num=1148781589
User avatar
nemo69
Posts: 326
Joined: Wed Feb 18, 2004 11:31 am
Location: Nowhere to be seen
Contact:

RE: Bolted Panel

Post by nemo69 »

ORIGINAL: Legun

try to hide control panel - it works for 1024*768 screen
I confirm: setting the taskbar on autohide lets you have the whole UI. I use it on my puny laptop limited to a 1024*768 resolution.
Fais ce que dois
User avatar
nemo69
Posts: 326
Joined: Wed Feb 18, 2004 11:31 am
Location: Nowhere to be seen
Contact:

RE: Bolted Panel

Post by nemo69 »

ORIGINAL: mantill
Is there another way of seeing the proportion of turn left in the game without using the bolted panel?
I'm afraid the answer's no. If you use the attack planner, you'll be able to see what percentage of the turn the planned combat should take, but not the amount of the turn used so far.
Fais ce que dois
User avatar
MarcA
Posts: 1181
Joined: Wed Mar 02, 2005 12:04 pm
Location: England

RE: Bolted Panel

Post by MarcA »

Thanks guys that did the trick
Image
Post Reply

Return to “TOAW III Support”