Adding Aircraft to facilities in scenario editor

[ManelFeio2007]

Hi,
I updated Harppon ANW to the last beta patch and I am unable to add aircraft using the usual Edit/Unit/Edit Aircraft/Add.
Nothing happens after pressing the buttons when adding aircraft to any facility other than runway. I tried both with Colonial Wars and Players DB.
I have no flag limiting units accordung to country or time.

Is it normal or a bug I couldn't find reported?[&:]

Many thanks,

[Sirius.]

Thats interesting as at the moment I'm building a scenario using the latest build and have no problems

[ManelFeio2007]

Thanks for the answer. It is looking like that something went wrong during the patch process.
If no one experiences the same problem I will make a fresh install...

[ManelFeio2007]

Well,
I installed it again and patched with the latest build 3.8.0.0 RC8.
Again tried to add aircraft to a revetment through the Edit/Unit/Edit Aircraft/Add to no avail. Nothing happens after the button was pressed!!!
In Harpoon ANW DB vs 2 I can't add a/c to revetments or hangars but it is possible to add to runways and airbases. The same doen't apply to Players DB or Colonial Wars DB.

Am I missing the effect of some obscure flag?...
Please someone to enlighten me...[&o]

The system is WinXP (updated regularly), Pentium 1.8, 512 MB ram, the location is d:\Matrix Games\Harpoon...

[FreekS]

maybe obvious, but your Revet I think must be part of a grouped airbase with Runway to add a/c.

Freek

[ManelFeio2007]

Thanks for the hypothesis.
In fact that seems to be the behaviour in H3 ANW DB vs 2. But, with Colonial WDB it doen't apply!...

As far as I can remember from the H2MM days the a/c where atributes of a facility and not of an instalation.
But those days are gone and I am probably wrong...

[Bucks]

Sounds like you haven't grouped the revetment with a valid runway. the individual facilities need to be grouped together to make the base function.

Here's an example. Say you have a revetment, 6ooo ft runway and an ammo dump. To enable all of these facilities to interact you need to hold down the mouse button and drag a box around the three facilities. Release the mouse button and then hit the "Group Units" Hotkey "G". - ( you can also hold down "shift" and individually click on each unit you wish to group together with your mouse and then hit the "G" Hotkey)

After you've done that I hope you'll find you be able to add and ready aircraft from your base.

Cheers

Darren

[ManelFeio2007]

FreekS and Bucks,
You are both quite right. The 'Small Airbase' installation present in the CW database has a serious problem: it doesn't have a runway!

As I said before new times new ways. I have learned my lesson.[;)]
Many thanks to you all