Scenario Editor problem

[rickier65]

I was going through the Scenario Editor to see what some of the choices are. This editor gives a lot of control (probably more than I can figure out how to use!).

One problem I found was in the Settings window.

When I Look at the RuleVars, and check either AI RuleVar Group or Combat Calcs rulevar group, the bottom part of the contents pane is cut off. for Rulevars, last AI rulevar # I see is 252; for Combat Calcs, the last rulevar# is 142. Looking at the slider it looks like tere are a few more entries below what I can see on screen.

I'm running at 1028x768. I'll try changing higher resolution and see if that shows more.

OK- just checked 1280X1024 resolution and it looks like just the bottom 4 rulevars are being chopped off at 1028x768.

It possoble this is just my set-up, and if so, no big deal, in fact might not be a big deal in any case (scenario designer could always slip into higher resolution to see those last few rulevars if necessary.

Thanks again Vic -

Rick


Thanks
Rick

[Vic]

noted it down for the patch after v1.02. (comming up soon)
 
thanks for telling me. I must have forgotten people with minimum resolution might be interested in editing too