A little help with scenario editing...

[jedijobu]

I am completely new to using the editor.

I would like to get some assistance in using it to edit the "Ironman" scenario - allies side - to take away all the restrictions on units - such as being able to load a unit to a transport that normally would not - such as loading NZ or Australian units to move off country, transfering air units to unrestricted bases, and so forth.


Also, If such a modification of the scenario is possible, would I have to start a new campaing game to use it, or would it be able to be used on a saved game

Thanks is advanced

[Andy Mac]

I think you would need to restart to see it take effect

OK there are two ways to do what you want to do the easy way and the hard way.

The easy way if all you care about are temp restricted units then the easy way is to set allied PP's per day to a really high number say 1000 per day then you will always have PP's to buy out units from restricted commands,.

(A few units will still not be buyable out but most of the restricted units can now be changed to an unrestricted command)

Thats the easy way,

The hard way is to go to each individual LCU or air group in the editor and untick from the left middle of the screen the three tick boxes to remove the static attached, restricted perm or restricted temp check boxes.

Andy

[jedijobu]

definately will just do the easy way then. I was only 4 days into the campaign so won't really sweat starting over.

thanks for the help

[jedijobu]

thanks a bunch. Went the "easy" way and doing what I want. Thanks

[Andy Mac]

Glad to help