AI attacking targets which i cant see on the map

[JERMofDK]

just to see how good the AI is i let it play a few AI vs AI full lenght BOB41 games.
I noticed that the AI made planned some REC missions for areas where there is just empty land. Later the AI planned some bombing missions on these targets, and in the AAR the targets are shown with damage. These targets are not on the target list when you check it the planning phase though..

[JERMofDK]

Uhh happy.. did not know if i could get the screen shot thing to work.
Anyways here is the bombing run to the BBFAC

[JERMofDK]

And here is the AAR which shows that the target is damaged..

[JERMofDK]

ohh and On another note.. It seems i and the AI can only damage the Service and runway part of airports there is never any comm damage. Am i missing something here or is it a bug??

[Hard Sarge]

the first part is corrected already, that was a site placed on 999 delay, that we found out could be targetted by the AI, which wasn't suppost to, so all have been pulled

why don't you get damage to Comm, I do ?

I do see, that you only show damage to Runway and service on the message report (it only shows up to 200 damage, but it does damage higher)

[Hard Sarge]

guess I did so much damage to Tangmere, that the last raid, went to Ford instead

(good TOO raids, splattered the small airfield and a Radar site

[Hard Sarge]

damage at the end of the day

(oddly, damage to Tangmere runway, was already being repaired and the enemy planes had not even turned around yet for the trip home)

[Hard Sarge]

and from the target list