Editing Manuever Value

[traskott]

Ok, so...I have added one plane with the editor, set manuever value=14 (i.e.) and left the slots related with altitude empty. When I go into the game the value which appear is zero.

The game will use then the "default" value or the airplane will be a truly "air brick".

Thank you in advance.

[topeverest]

What class airframe did you make? what are the specifics. Non fighters do not have altitude range settings, so if that is the case, it is appropritate

[traskott]

It was a fighter. I set manouver to 26, left 0 at all ranges but one (+31k) which set to 17 ( whatever)

[topeverest]

Then, in the editor on the Aircraft screen, pull up the new airframe. to the right of Maneuver, there is a box for the altittude ratings. you need to poulate all settings and select a service rating. Otherwise, I think she will be that brick.

[traskott]

Ok, so it's necesary fill up all settings. xDDDD Damn, I have added no less than 20 planes... Uffff. Ok. Thank you !!!

[PaxMondo]

Using witploadae with the .csv files can greatly speed up these types of edits.

[traskott]

How it works? Where can I find about it ? Thank you !!!

[topeverest]

You already have it in all likelihood, in your AE / Scenario folder...look for that name.

Requires higher applications programming IQ - not for the unititiated, especially if you make a keystrike error and have to trace the problem. Keep a good record of what you execute and you should be fine.

[traskott]

Uhhh...Looks like it will be faster by hand, and with less risk of data loss. Thanks for the info