Undo Move Button

[Manstein63]

Is it possible that the undo move button can be set so that if you move 2 units & realise that you only meant to move one unit you can undo the move. I am playing a PBEM & I was setting up a pocket around Minsk so I broke down a panzer division to form some blocking units moved one into position for got to select a second rgt to move so the remaining 2 rgt's both moved to a hex that I had intended just for one rgt & because one moves straight after the other the undo move button was not availiable. I admit that I should have realised what was going to happen & that some wag will say something about it being a C & C issue but if you are allowed to undo one unit's move then surely the same should apply for 2 units occupying the same hex as this also happens with larger units as well.
Manstein63

[cookie monster]

You can undo a move for two selected units however undo move is not available if...

Players can undo a move (‘undo’ button or hot key ‘u’) unless the move resulted in air
interdiction, turned an enemy hex into a pending friendly hex, attacked an enemy unit or
spotted an enemy unit that previously had a detection level of zero.

[Manstein63]

Thanks for the info I think that I should read the manual but at least there is a reason that you can only use the undo button sometimes
Manstein63