Adding new unit

Post discussions and advice on TOAW scenario design here.

Moderators: ralphtricky, JAMiAM

Post Reply
User avatar
BigDuke66
Posts: 2035
Joined: Thu Feb 01, 2001 10:00 am
Location: Terra

Adding new unit

Post by BigDuke66 »

Man this editor drives me nuts.
Finally got to add a new unit without killing anything else(at least i hope so), I also set an objective but the check still shows me:
"Use Edit Deployment to set all force 2 formation objectives. (critical)"
So what's the bloody point?
User avatar
Curtis Lemay
Posts: 15050
Joined: Fri Sep 17, 2004 3:12 pm
Location: Houston, TX

RE: Adding new unit

Post by Curtis Lemay »

ORIGINAL: BigDuke66

Man this editor drives me nuts.
Finally got to add a new unit without killing anything else(at least i hope so), I also set an objective but the check still shows me:
"Use Edit Deployment to set all force 2 formation objectives. (critical)"
So what's the bloody point?

At least one Force 2 formation lacks any objectives. Did you add formations? If so, they each need at least one objective.
My TOAW web site:

Bob Cross's TOAW Site
User avatar
BigDuke66
Posts: 2035
Joined: Thu Feb 01, 2001 10:00 am
Location: Terra

RE: Adding new unit

Post by BigDuke66 »

First I thought it was because I added a formation, but I checked back and it was there before. God thanks for the scenario viewer, I found the formation without objective.
Thanks.
User avatar
Panama
Posts: 1362
Joined: Fri Oct 30, 2009 1:48 pm

RE: Adding new unit

Post by Panama »

Yeah. The editor is not very friendly, especially if you are new to it.
Post Reply

Return to “Scenario Design”