Units Selection

This forum is for official support and troubleshooting FAQs.

Moderator: Jason Petho

Post Reply
sobibor
Posts: 15
Joined: Wed Mar 19, 2008 9:42 pm

Units Selection

Post by sobibor »

How can i select some especific units inside an hex (not all the units inside, only some)? i remember on original Talonsoft I was able to do that but now i can't...
Top
User avatar
junk2drive
Posts: 12856
Joined: Thu Jun 27, 2002 7:27 am
Location: Arizona West Coast

RE: Units Selection

Post by junk2drive »

Click the hex with units in it. Press the U key to turn on the side bar that shows the units in the hex. Click the units in the side bar and see that their title highlights. You can also double click the hex to select all the units then click the side bar to deselect as needed.
Conflict of Heroes "Most games are like checkers or chess and some have dice and cards involved too. This game plays like checkers but you think like chess and the dice and cards can change everything in real time."
Top
sobibor
Posts: 15
Joined: Wed Mar 19, 2008 9:42 pm

RE: Units Selection

Post by sobibor »

oh, the "U" key; thank you very much
Top
User avatar
Warhorse
Posts: 5373
Joined: Fri May 12, 2000 8:00 am
Location: Birdsboro, PA, USA
Contact:
Contact Warhorse

RE: Units Selection

Post by Warhorse »

I usually, if in 2D mode, click the hex, then when the infobox is up, keep right-clicking through all the units until who I want. you can highlight thn any one of them for a place-setter to tell where you are. Hope this helps as well!
Mike Amos

Meine Ehre heißt Treue
www.cslegion.com
Top
Post Reply

Return to “John Tiller’s Campaign Series Support”