Access Violation Error Message

[kool_kat]

Gents: [8D]

I'm developing a scenario, but receiving an access violation error message after I selected my initial forces.

Can you take a look at the scenario file? Let me know how to correct the error message? [&:]

File attached.

[kool_kat]

Gents: [8D]

NVM. File is working correctly now. I "believe" some of the units were not in valid setup hexes when
I first selected the forces? [&:]

[CapnDarwin]

We will check it out this evening and let you know what we see.

[cbelva]

Mike, which force were you selecting? Did it give the access violation as you "selected the force" or when you tried to save it? Thanks
 

[kool_kat]

ORIGINAL: cbelva

Mike, which force were you selecting? Did it give the access violation as you "selected the force" or when you tried to save it? Thanks

I was receiving the error message when I selected either Force 1 or Force 2. I would click on a unit and immediately
the error message would display. However, all error messages were prior to the scenario being saved for
the first time.

Note - I am able to load the saved scenario, click on units, move them etc. with no error message displaying.

Maybe the error message is associated only when all the initial scenario perimeters not being met? (e.g. Must have a
player briefing for each side. Must have at least one victory hex, etc.)