How to create a supply point?

[track12345678]

I'm new and I wanted to try out the scenario editor, so I decided to create a small 20x20 desert battle. Yet for whatever reason the units that I place end up under-supplied and end up disbanding within a few turns. I've read through most of the scenario manual and I have yet to see a page mentioning supply and how it functions. If someone would kindly explain to me how to create supply points, then I would be most grateful.

[Curtis Lemay]

ORIGINAL: track12345678

I'm new and I wanted to try out the scenario editor, so I decided to create a small 20x20 desert battle. Yet for whatever reason the units that I place end up under-supplied and end up disbanding within a few turns. I've read through most of the scenario manual and I have yet to see a page mentioning supply and how it functions. If someone would kindly explain to me how to create supply points, then I would be most grateful.

Supply Points can be placed via the Deployment Editor (17.11.3 and specifically 17.11.14) or via the Event Editor (17.9.4).

[Oberst_Klink]

ORIGINAL: track12345678

I'm new and I wanted to try out the scenario editor, so I decided to create a small 20x20 desert battle. Yet for whatever reason the units that I place end up under-supplied and end up disbanding within a few turns. I've read through most of the scenario manual and I have yet to see a page mentioning supply and how it functions. If someone would kindly explain to me how to create supply points, then I would be most grateful.

I made a small Editor Tutorial - Tutorial '42 - Editor: tm.asp?m=4401098
Feel free to play around with the scenario file.

Klink, Oberst

[MikeJ19]

Good day Brim,

Here is a look at supply in general.

tm.asp?m=4486293

Have a good day,

[rhinobones]

The replies do not mention it, but supply point ownership can be programed by the scenario author as a) side 1 only, b) side 2 only or c) side 1 or 2 depending on ownership of the supply point hex.

Initial ownership of the supply point is programed by the scenario author.

Regards, RhinoBones

[76mm]

ORIGINAL: rhinobones
The replies do not mention it, but supply point ownership can be programed by the scenario author as a) side 1 only, b) side 2 only or c) side 1 or 2 depending on ownership of the supply point hex.

Does that have to be done through an Event, or is there any easier way to do it?

[sPzAbt653]

By Event or manually in the Editor [as seen below].