Damage

SPWaW is a tactical squad-level World War II game on single platoon or up to an entire battalion through Europe and the Pacific (1939 to 1945).

Moderator: MOD_SPWaW

Post Reply
joblue
Posts: 54
Joined: Wed May 10, 2000 8:00 am
Location: Brooklyn, USA

Damage

Post by joblue »

Where can one find out how much damage each individual unit can sustain...also, is supression on a scale of 1:10 or 1:100?

Thanks

Joblue
User avatar
Paul Vebber
Posts: 5342
Joined: Wed Mar 29, 2000 4:00 pm
Location: Portsmouth RI
Contact:

Post by Paul Vebber »

Infantry units lose a man for every caualty, suppression goes up to 99, 0 suppression means you get teh best hit chances, once you start getting shot at, you suffer about a 25-50 degradation based on experence - teh first few points of suppression do the most, once you get over 20-30 its more a matter of how far you head is between your knees...

Every time you "rally" suppression ios cut in half bt once you get shot at you are stuck at 1 minimum.

Every "*" when a vehicle is hit means a system or crewman is knocked out. Teh more stars the more suppression vehicles take.

When your suppression reaaches a certain fraction of your morale you become pinned (buttoned for vehicles), then retreated and finally routed, as you rally the suppression below teh threasholds, you get improvement in staus. IF you keep shooting at retreated or routed troops, occasionally they figure its better to go down fighting and spontaneously go to pinned and stop running away. Russians in delay or defend mission can "fanatically" go from routed or retreated back to good order again.

[This message has been edited by Paul Vebber (edited 05-12-2000).]
joblue
Posts: 54
Joined: Wed May 10, 2000 8:00 am
Location: Brooklyn, USA

Post by joblue »

Thanks for the supresion definition. I guess I didnt phrase my other question as clearly. It was: how can I find out how much damage points a particular piece of equipment has.

Joblue
User avatar
Paul Vebber
Posts: 5342
Joined: Wed Mar 29, 2000 4:00 pm
Location: Portsmouth RI
Contact:

Post by Paul Vebber »

OH - when you select a unit, right click or hit hte space bar and teh unit status screen will ocme up. It will give you a complete rundown on the units status
joblue
Posts: 54
Joined: Wed May 10, 2000 8:00 am
Location: Brooklyn, USA

Post by joblue »

yeah, I can see the unit status, and the damage says "0" (at the beginning of the battle). My question is, how many points of damage can a unit sustain before being destroyed (ie, a T34 can sustain "xx" damage points before being destroyed)

Thanks for your time and patience!!!

Joblue
Post Reply

Return to “Steel Panthers World At War & Mega Campaigns”