Max Supply Levels for Force, Form, Units?

Post new mods and scenarios here
Post Reply
User avatar
76mm
Posts: 4768
Joined: Sun May 02, 2004 4:26 am
Location: Washington, DC

Max Supply Levels for Force, Form, Units?

Post by 76mm »

I'm fixing TOAWxml so that it places the proper limits on supply levels for forces, formations, and units.

From what I could tell from the manual, the limits are as follows:

Force: 100

Formation: ? Couldn't find anything in manual--is the upper limit for formation supply levels also 100?

Units: Not sure that I found an upper limit, but it can be more than 100; during setup can exceed 150, and during a game cannot exceed 150. Anybody see an issue if I put a max of 200?
User avatar
sPzAbt653
Posts: 10160
Joined: Thu May 03, 2007 7:11 am
Location: east coast, usa

RE: Max Supply Levels for Force, Form, Units?

Post by sPzAbt653 »

100 - 100 - 150 is correct. I just tried making it 200 for a unit and it defaulted to 150, so maybe 150 is it for units.
User avatar
76mm
Posts: 4768
Joined: Sun May 02, 2004 4:26 am
Location: Washington, DC

RE: Max Supply Levels for Force, Form, Units?

Post by 76mm »

Thanks much. Looks like the manual should be corrected here then as well, because the last paragraph on page 55 says:

"Units may begin a Scenario with a level greater than 150%, but Supply Levels may not be increased above 150% during the course of a Scenario. Any oversupplied unit (with a Supply Level greater than 100%) will lose its excess supplies if it moves."

I'll try entering above 150 as well to see what happens, although I don't expect anything different from what you're saying. But then again, maybe the manual is correct, and the failure to accept values over 150 could be an error?
User avatar
Lobster
Posts: 5582
Joined: Thu Aug 08, 2013 2:12 pm
Location: Third rock from the Sun.

RE: Max Supply Levels for Force, Form, Units?

Post by Lobster »

Huh. I wonder if that is yet another undiscovered bug.
ne nothi tere te deorsum (don't let the bastards grind you down)

If duct tape doesn't fix it then you are not using enough duct tape.

Two things are infinite: the universe and human stupidity and I’m not sure about the universe-Einstein.
User avatar
sPzAbt653
Posts: 10160
Joined: Thu May 03, 2007 7:11 am
Location: east coast, usa

RE: Max Supply Levels for Force, Form, Units?

Post by sPzAbt653 »

I also tried 3.4.1.9 and 3.4.0.202 but could only set the Unit Supply Level up to 150. The 'greater than 150' bit isn't ringing any bells ... I can't think of what that was referencing.
Post Reply

Return to “Mods and Scenarios”