Bomber unit not accepting reinforcements

[Lascar]

For some reason certain air units are not accepting reinforcements to replace their loses.
The British strategic bomber No. 4 Hvy Bmbr. has been set to receive priority replacements since 1939
and is within HQ command range. The repair/upgrade enabled within command range has been activated.
30 production points have been allocated for upgrade/repairs.

A number of French air units are also experiencing this problem

Any ideas as to why this is happening?

[Michael T]

Make sure it is the only unit set to priority.

[TrogusP96]

I've had the same problem with the same unit. On the Russian front the units seem to upgrade from north to south and if a 1931 upgrade hits before all are done then it starts over. I thought it was random. The rationale was it would reduce micromanaging of adding the replacements but I seem to be doing just as much turning upgrade/reinforcement on and off. Is there some priority under the hood based on unit type, reinforcement versus upgrade, location etc. proximity to city of HQ?

[AlbertN]

While I experience the same issue with reinforcing planes - they do get reinforced just they're extremely costy so even to repair -1- point it takes a helluva of production point.

So for instance an infantry Health Point costs 6 I believe (unless discounts are applied) at the '39 quality.
I may have read in the forums that there is a 20% discount when just repairing so make it 5.

Now let's take a fighter. 250 cost at 39 tier. 20 HP. So 12.5 production (or 10ish if there is a discount) per health point.

That's just bound to ramp up as the technologies escalates.

So to repair 30 is like ... 1-2 points of a strat-bomber. And as Michael said, make sure it is the only one with priority.

[AlvaroSousa]

There is an order of replacement chart in the manual. When someone has this problem it so far has been on the user side.