Where do I put a Supply Base?

Moderator: Vic

User avatar
Malevolence
Posts: 1798
Joined: Sat Apr 03, 2010 11:12 am

Where do I put a Supply Base?

Post by Malevolence »

Supply Bases provide Truck Action Points, not Truck Points (TP).

The best place to build them is situational.

Truck Action Points are non-cumulative and the the highest producing Asset is used to provide Truck Action Points.

These are basically range points and a City will have its full amount of Truck Points projected within this range. After the range is exceeded the % of Truck Points projected slowly drops to 0 upon reaching hexes at double the range or more.

Ideally you place them at the hex before you have the first reduction in TPs.

Use Preview Points to determine this hex location (see below diagram). I use stop signs to cut off all outside TP and rail points on the Preview view first. By removing TPs from other more distant truck stations, the view is limited to the closest truck station's output of TP's.

Multiple supply bases do not extend. Truck Action Point Extensions are not cumulative and constructing another Supply Base does increase the range any further. I believe they are specifically designed to sit between two truck stations.

You want to keep one supply base at equal distance between two truck stations. Just within the Truck Action point range of each Truck Station.

Ostensibly, a Supply Base III should create a perfectly efficient supply route between two Truck Station I's at 20 hexes distant.

Supply Bases make excellent locations for road junctions.

If you upgrade the truck station, the truck points increase and truck action points increase slightly. The most favorable hex will change.

Code: Select all

                   --------------------------------------------------------------------------------------------------------------
                   | city or road  |  road   |  road   |  road   |  road   |  road       |  road   |  road   |  road   |        |
                   | hex 0         |  hex +  |  hex +  |  hex +  |  hex +  |  hex 10     |  hex +  |  hex +  |  hex 15 |  etc   |
 --------------------------------------------------------------------------------------------------------------------------------
 | without supply  | truck station |         |         |         |         |             |         |         |         |        |
 | base            | 1000 TP       | 1000 TP | 1000 TP | 1000 TP | 1000 TP | 1000 TP     | 900 TP  | 800 TP  | 700 TP  |  etc   |
 --------------------------------------------------------------------------------------------------------------------------------
 | with supply     | truck station |         |         |         |         | supply base |         |         |         |        |
 | base            | 1000 TP       | 1000 TP | 1000 TP | 1000 TP | 1000 TP | 1000 TP     | 1000 TP | 1000 TP | 1000 TP |  etc   |
 --------------------------------------------------------------------------------------------------------------------------------
 
 -----------------------------------------------------------------------------
 | Supply Base I   |  +50 Truck Action Point Extension   |  extended ~5 hex  |
 | Supply Base II  |  +75 Truck Action Point Extension   |  extended ~7 hex  |
 | Supply Base III |  +100 Truck Action Point Extension  |  extended ~10 hex |
 -----------------------------------------------------------------------------
 
 * these numbers are estimates as the number of truck action points needed to move from one hex to another can be impacted by terrain modifiers.
 
Nicht kleckern, sondern klotzen!

*Please remember all posts are made by a malevolent, autocratic despot whose rule is marked by unjust severity and arbitrary behavior. Your experiences may vary.
LordAldrich
Posts: 95
Joined: Tue Sep 30, 2014 4:53 pm

RE: Where do I put a Supply Base?

Post by LordAldrich »

I was under the impression that because Truck AP is additive and does not degrade with distance, you get the exact same outcome if you put the supply base in "hex 1" right next to your city. There's no need to find the optimal tile unless you're trying to make sure it boosts two separate truck stations down a shared road, or some similarly niche application.
EatPancakes
Posts: 4
Joined: Sun Jun 21, 2020 9:41 pm

RE: Where do I put a Supply Base?

Post by EatPancakes »

I agree that 1 space besides cities seem optimal, most of the time.
User avatar
Malevolence
Posts: 1798
Joined: Sat Apr 03, 2010 11:12 am

RE: Where do I put a Supply Base?

Post by Malevolence »

You want to keep one supply base at equal distance between two truck stations. Just within the Truck Action point range of the Truck Stations. As I also wrote, this a good place for road junctions.

Multiple supply bases do not extend. Truck Action Point Extensions are not cumulative and constructing another Supply Base does increase the range any further. I believe they are specifically designed to sit between two truck stations.

Ostensibly, a Supply Base III should create a perfectly efficient supply route between two Truck Station I's at 20 hexes distant.

Nicht kleckern, sondern klotzen!

*Please remember all posts are made by a malevolent, autocratic despot whose rule is marked by unjust severity and arbitrary behavior. Your experiences may vary.
zgrssd
Posts: 5105
Joined: Tue Jun 09, 2020 1:02 pm

RE: Where do I put a Supply Base?

Post by zgrssd »

While you currently can place it just one hex outside the city - or even in the hex with a trucks station in the wild! - 1 base benefiting 2 or more truck stations is better.

Plus the "1 hex exploit" can be fixed. I actually can think of a way.
ramnblam
Posts: 216
Joined: Tue Jun 09, 2020 9:40 am
Location: Australia

RE: Where do I put a Supply Base?

Post by ramnblam »

Is there any way to tell if a hex is under the affect of a supply base? And do supply bases give administration strain If they do, they're not worth it.
zgrssd
Posts: 5105
Joined: Tue Jun 09, 2020 1:02 pm

RE: Where do I put a Supply Base?

Post by zgrssd »

ORIGINAL: ramnblam

Is there any way to tell if a hex is under the affect of a supply base? And do supply bases give administration strain If they do, they're not worth it.
The first question makes no sense. Truck Lines are under the effect of a supply base, not hexes. And the Supply base in a hex is rather easy to spot...

The seocnd question: Just do not put them outside of 6 hexes, if the do. Or you know, compare it to a Truckstop at the same spot. And realize teh supply base may still be better.
User avatar
Jdane
Posts: 456
Joined: Thu Jun 04, 2020 11:12 pm

RE: Where do I put a Supply Base?

Post by Jdane »

You can see the effect of a supply base in a hex when using the Traffic Signs tool. It breaks down the usage of original Action Points and Truck Action Points to use the OP's terminology, displaying them separately (look into the detailed stats in the right hand view).
ramnblam
Posts: 216
Joined: Tue Jun 09, 2020 9:40 am
Location: Australia

RE: Where do I put a Supply Base?

Post by ramnblam »

Thanks Jdane <3
User avatar
Malevolence
Posts: 1798
Joined: Sat Apr 03, 2010 11:12 am

RE: Where do I put a Supply Base?

Post by Malevolence »

ORIGINAL: ramnblam

Is there any way to tell if a hex is under the affect of a supply base? And do supply bases give administration strain If they do, they're not worth it.

There is no penalty for 9% administrative strain and below.

Even with uncontrollable private assets, I have never come close to 10% or more.

Did you know you can delegate supply bases to another zone?
Nicht kleckern, sondern klotzen!

*Please remember all posts are made by a malevolent, autocratic despot whose rule is marked by unjust severity and arbitrary behavior. Your experiences may vary.
Kamelpov
Posts: 167
Joined: Sat Feb 22, 2020 6:59 pm

RE: Where do I put a Supply Base?

Post by Kamelpov »

The best location is under a colonized new city at the same location than the supply truck. (as it wasn't a city hex at the beginning but once you put settler you can't build that anymore.)
LordAldrich
Posts: 95
Joined: Tue Sep 30, 2014 4:53 pm

RE: Where do I put a Supply Base?

Post by LordAldrich »

ORIGINAL: Kamelpov

The best location is under a colonized new city at the same location than the supply truck. (as it wasn't a city hex at the beginning but once you put settler you can't build that anymore.)

Now THAT is definitely a bug. You're obviously not supposed to be able to build them in cities.
zgrssd
Posts: 5105
Joined: Tue Jun 09, 2020 1:02 pm

RE: Where do I put a Supply Base?

Post by zgrssd »

ORIGINAL: LordAldrich

ORIGINAL: Kamelpov

The best location is under a colonized new city at the same location than the supply truck. (as it wasn't a city hex at the beginning but once you put settler you can't build that anymore.)

Now THAT is definitely a bug. You're obviously not supposed to be able to build them in cities.
But you are able to build a city on top of them [;)]
User avatar
Malevolence
Posts: 1798
Joined: Sat Apr 03, 2010 11:12 am

RE: Where do I put a Supply Base?

Post by Malevolence »

Open Beta Patch v1.04-beta1 made changes to the supply base.
ORIGINAL: Vic
-Changed the way Supply Bases are giving extension. They now only give extension points upto the point normal action points have already been used. This makes them function as actually intended. Will only be in effect with games started with v1.04-beta1

The beta change requires a new start--"Version #41" in your Dashboard Report.

Keep in mind, the patch only works if installed only over the official update v1.04.
Nicht kleckern, sondern klotzen!

*Please remember all posts are made by a malevolent, autocratic despot whose rule is marked by unjust severity and arbitrary behavior. Your experiences may vary.
User avatar
Malevolence
Posts: 1798
Joined: Sat Apr 03, 2010 11:12 am

RE: Where do I put a Supply Base?

Post by Malevolence »

Shamelessly quoted from Destragon:
ORIGINAL: Destragon

If someone still didn't understand the change, here is a small example:

This supply base could potentially replenish 50 movement points, but because the logistics path has only spent 20 movement points so far when it reached the supply base, it is only able to replenish 20.

Image

In the old version, it would have given 50 extra movement points, no matter how many movement points the logistics path has already used up.

They used to give extra movement points for the logistics trucks, now they only replenish spent movement points, which means you need to put your supply base farther away from your truck station to make it more effective.
Nicht kleckern, sondern klotzen!

*Please remember all posts are made by a malevolent, autocratic despot whose rule is marked by unjust severity and arbitrary behavior. Your experiences may vary.
NoodlePickle
Posts: 21
Joined: Tue Oct 15, 2019 1:04 am

RE: Where do I put a Supply Base?

Post by NoodlePickle »

Regarding the image above and things about it that I do not understand or know where to find the info....
1. Where can I find the receive and sent information in game? I cannot figure that out.
2. The line used 20 of 100 AP and then replaced the 20 AP. That makes sense, but what does the ext=10/20 mean exactly, I read it as extending 20AP, but why the 10/20?
3. What is BR? And how will that information confuse me at a later date?

Thank you
Falke
Posts: 179
Joined: Fri Aug 13, 2004 10:11 am

RE: Where do I put a Supply Base?

Post by Falke »

1. Traffic signs mode - click on hex
2. It means 10 of the 20 extra is used sending it to the next hex
zgrssd
Posts: 5105
Joined: Tue Jun 09, 2020 1:02 pm

RE: Where do I put a Supply Base?

Post by zgrssd »

ORIGINAL: NoodlePickle

Regarding the image above and things about it that I do not understand or know where to find the info....
1. Where can I find the receive and sent information in game? I cannot figure that out.
2. The line used 20 of 100 AP and then replaced the 20 AP. That makes sense, but what does the ext=10/20 mean exactly, I read it as extending 20AP, but why the 10/20?
3. What is BR? And how will that information confuse me at a later date?

Thank you
1. Traffic Sign Menu. Click on a Hex
2. How much extension was already applied to that line. To my understanding, tehy are not supposed to stack. So the game needs some way to remember "10 AP of extension were alrady applied"
3. Number of branches. After over 4, there are additional AP penalties.
demiare
Posts: 470
Joined: Sat Jun 20, 2020 4:21 pm

RE: Where do I put a Supply Base?

Post by demiare »

Since 1.04 beta1 Supply Bases had received a small rework:

1) They're providing EXTRA move points, not replenish existing.
2) Their effects do not stack.

Nothing changed in calculation except ideal place for supply base - you can (and IMHO should!) place it inside 6-hex range of city (to avoid administrative strain penalty).
User avatar
Malevolence
Posts: 1798
Joined: Sat Apr 03, 2010 11:12 am

RE: Where do I put a Supply Base?

Post by Malevolence »

ORIGINAL: demiare

Since 1.04 beta1 Supply Bases had received a small rework:

1) They're providing EXTRA move points, not replenish existing.
2) Their effects do not stack.

That is what the OP states.
ORIGINAL: demiare

Nothing changed in calculation except ideal place for supply base - you can (and IMHO should!) place it inside 6-hex range of city (to avoid administrative strain penalty).

That is not a hard and fast rule. The first 9% of administrative strain has no impact.

Depending on circumstances, and a player's future plans, an insightful and informed analysis should be made before placing the supply base.

A more significant consideration is the location of the next truck station along the route.
Nicht kleckern, sondern klotzen!

*Please remember all posts are made by a malevolent, autocratic despot whose rule is marked by unjust severity and arbitrary behavior. Your experiences may vary.
Post Reply

Return to “War Room”