Question to Events

[sdplate]

I have a question for experienced modders or the developers. On page 142, paragraph 3.1.27 of the manual it says: "Decision Events that do not contain a #POPUP entry are treated as an automatic 'YES' decision selection. This can be can be useful in campaign design as a trigger ..." I understood this concept, applied it and it works. So far so good. But now I would like that a trigger event is not automatically assigned with 'YES' but instead with 'NO'. Is that possible and if so, how? Or is there a workaround to automatically assign 'NO' to an event without the player being involved?

sdplate

[El_Condoro]

Instead of #LINK= ##[1] use #LINK= ##[0] in the event you want to fire off the first event (##)

[BillRunacre]

This is a bit tricky, as dummy DEs only have one outcome (yes).

If the Decision should sometimes have a yes response and sometimes a no, then either it needs to be player controlled or you will need to use more than one Decision for the same thing.

Using more than one is possible as then you just assign them different gv numbers.

But any scripts set to fire off a dummy Decision need to be set to yes.