Air directives issue

[Strategicon]

I have a big issue with the Air directives between two turns.
a) AI assist off.
b) In the air phase the previous air directives have been deleted.
c) New air directives are then created.
d) When resolving the air phase, the old air directives are applied (those which have been removed and replaced by the new ones) and not the new air directives.
e) At the end of the air resolution phase the "Show air directive summary" screen shows the old directives from previous turns which had been cleared and not the new air directives which had to be applied.

The problem persists for several turns, for several turns, during each new air resolution phase the new air directives are replaced by those which had been cleared.

[Joel Billings]

I sent you an email, but the basic issue is you have Auto AI Air Assist on so you will get this behavior. Turn it off and press the button when you want it to create new ADs and then adjust them afterwards and you will be ok.