Why have BF110E-2s(bombers) performing SWEEP... ?

A complete overhaul and re-development of Gary Grigsby's War in the East, with a focus on improvements to historical accuracy, realism, user interface and AI.

Moderator: Joel Billings

Post Reply
DarkHorse2
Posts: 1070
Joined: Fri Feb 04, 2022 12:08 pm

Why have BF110E-2s(bombers) performing SWEEP... ?

Post by DarkHorse2 »

I have all of SKG 210 trained as "Bomber" and assigned mission is "Bomber".

I also have them assigned to a Ground Support directive.

However, I also see them performing SWEEP operations as well.

Why have fighter-bombers performing SWEEP operations while on ground support directive, yet it doesn't do anything?
WiTE2_sweep.JPG
WiTE2_sweep.JPG (76.51 KiB) Viewed 352 times
I checked the log file as well, those flying ESCORT fired, but nothing from the AC flying SWEEP.
WiTE2_escort.JPG
WiTE2_escort.JPG (97.69 KiB) Viewed 346 times
Historically, yeah after a fighter-bomber dropped its load, it would often linger over the target and perform more of a fighter role for the remaining mission time over the target. But in this case, the SWEEP did absolutely nothing. (the bombing barely did anything... so much for the GS is OP argument. :lol: )

Is this typical or WAD?

EDIT:

Here is the "Air Mission" listing from the "General Info" tab. Nothing about SWEEP here. :?: :?: :?:
WiTE2_AirMissions.JPG
WiTE2_AirMissions.JPG (15.6 KiB) Viewed 347 times
and the following is the Bf-110E-2 bombing log. (only 26 actually bombed out of 84)
68,4,Bf 110E-2 damaged by FLAK
68,4,Bf 110E-2 damaged by FLAK
68,4,Bf 110E-2 damaged by FLAK
68,4,Bf 110E-2 damaged by FLAK
68,4,Bf 110E-2 damaged by FLAK
68,4,Bf 110E-2 damaged by FLAK

...

68,3,12 x Bf 110E-2 bombing 140th Rifle Division
68,6,122mm M1910 Howitzer disrupted by 50kg GPHE Bomb (air)
68,6,122mm M1910 Howitzer disrupted by 50kg GPHE Bomb (air)
68,6,76.2mm 3-K AA Gun disrupted by 50kg GPHE Bomb (air)
68,3,2 x Bf 110E-2 bombing 140th Rifle Division
68,6,50mm M40/41 Mortar disrupted by 7.92mm MG 17 (air)
68,3,12 x Bf 110E-2 bombing 140th Rifle Division
68,6,76.2mm M27 Infantry Gun disrupted by 50kg GPHE Bomb (air)
68,6,7.62mm Maxim Machine Gun disrupted by 50kg GPHE Bomb (air)
68,6,Support disrupted by 50kg GPHE Bomb (air)
68,6,76.2mm M27 Infantry Gun disrupted by 50kg GPHE Bomb (air)
68,6,Rifle Squad 41 disrupted by 20mm Cannon MG FF/M (air)
68,6,Support disrupted by 20mm Cannon MG FF/M (air)
68,6,50mm M40/41 Mortar disrupted by 50kg GPHE Bomb (air)
68,6,45mm M37 AT Gun disrupted by 7.92mm MG 17 (air)
68,6,Support disrupted by 50kg GPHE Bomb (air)
DarkHorse2
Posts: 1070
Joined: Fri Feb 04, 2022 12:08 pm

Re: Why have BF110E-2s(bombers) performing SWEEP... ?

Post by DarkHorse2 »

This is using them again for a 2nd Ground Support mission against an adjacent hex (to the previously attacked hex).

This is actually what I would have expected.
WiTE2_no_sweep.JPG
WiTE2_no_sweep.JPG (76.65 KiB) Viewed 332 times
What did I do differently this time?

I cleared the load-outs on each one of the Bf110E-2s and then set it back.

No idea if this had anything to do with it or not.
User avatar
Hardradi
Posts: 836
Joined: Wed Feb 09, 2011 8:16 am
Location: Swan River Colony

Re: Why have BF110E-2s(bombers) performing SWEEP... ?

Post by Hardradi »

Its typical for fighter bombers and documented in the manual.

How are you able to identify which aircraft are which in the battle log?
Post Reply

Return to “Gary Grigsby's War in the East 2”