Rookie II - Saving MacArthur - against opponent no. 5

[Leandros]

Brisbane Evening Star January 25th 1944 - page 5

[Leandros]

Brisbane Evening Star January 31st 1944 - pages 1 - 2

[Leandros]

Brisbane Evening Star January 31st 1944 - pages 3 - 4

[Leandros]

Brisbane Evening Star January 31st 1944 - pages 5 - 6

[Leandros]

Brisbane Evening Star February 5th 1944 - pages 1 - 2

[Leandros]

Brisbane Evening Star February 5th 1944 - pages 3 - 4

[Leandros]

Brisbane Evening Star February 10th 1944 - pages 1 - 2

[Leandros]

Brisbane Evening Star Febuary 10th 1944 - pages 3 - 4

[Leandros]

Brisbane Evening Star February 15th 1944 - pages 1 - 2

[Leandros]

Brisbane Evening Star February 15th 1944 - page 3

[Leandros]

Brisbane Evening Star February 20th 1944 - pages 1 - 2

[Leandros]

Brisbane Evening Star February 20th 1944 - pages 3 - 4

[Leandros]

Brisbane Evening Star February 20th 1944 - page 5

[Leandros]

Hi, guys - I have a question to you guys (if any) reading my postings: On my laptop screen only about 2/3 of the center of my screen is showing the actual postings, the rest is a black frame. Is it the same for you? I would have liked to have the text fill the whole screen for better readability. I have tried to find an adjustment for this but cannot find one. Any suggestions?

Fred
-----

[BBfanboy]

In the upper right of the forum click on your user name and choose "User Control Panel".
Then click on the tab "Board Preferences" and change the board type to Matrix- wide. That is as wide as the board lets you get with your native resolution.

After that, I used the Zoom feature (CTRL and mouse wheel IIRC) to widen my view until the black was all covered. This makes for more legible text for my old eyes and I have my Windows strip showing on the right side of the screen where it does not interfere with anything.

EDIT: I should mention I have a 32" monitor so that is a good deal of zooming!

[Leandros]

In the upper right of the forum click on your user name and choose "User Control Panel".
Then click on the tab "Board Preferences" and change the board type to Matrix- wide. That is as wide as the board lets you get with your native resolution.

After that, I used the Zoom feature (CTRL and mouse wheel IIRC) to widen my view until the black was all covered. This makes for more legible text for my old eyes and I have my Windows strip showing on the right side of the screen where it does not interfere with anything.

EDIT: I should mention I have a 32" monitor so that is a good deal of zooming!

Thank you, BB - that did the trick!

Fred

[Leandros]

Brisbane Evening Star February 29th 1944 - pages 1 - 2

[Leandros]

Brisbane Evening Star February 29th 1944 - pages 3 - 4

[Leandros]

Brisbane Evening Star February 29th 1944 - pages 5 - 6

[Leandros]

Brisbane Evening Star February 29th 1944 - pages 7 - 8