Editor: Making a huge "copy-paste" and another question

[traskott]

Questions:

a) Is it posible with the editor cut more than one slot and move them to a new position, to make changes "in masse" ?

b) Is it posible do the same ( cut more than one slot ), then loading a new scen and then paste on it ?

Thank you...

[topeverest]

I have not found a way to do that either of those things inside the GUI.

If you do / are adept at editing at the database level (outside the GUI), you can do this in many cases with a mass update.

[traskott]

With the excel ?? 

[michaelm75au]

There is a tool 'witpload' that allows data to be exported into Excel, changed and then imported back into the scenario data files.

[traskott]

Thank you VERY much..

[&o][&o][&o][&o]

edit: Eehhh, uuuh. how I can distribute the data all over the excel files to get a plain view.

Now I see all data in just one or two columns and it's a mess!!

[Shark7]

ORIGINAL: michaelm

There is a tool 'witpload' that allows data to be exported into Excel, changed and then imported back into the scenario data files.

Where might one find this tool?

[topeverest]

In the scenario folder...not a GUI

[traskott]

It must be launched from MS-DOS, but is very useful....

[topeverest]

If someone has a tutorial on using this, I would love to see it.  I've tried it a few times and not been terribly successful.

[Shark7]

OK, I can do that, once I figure out how to get a DOS prompt from Windows 7. [:D]

[traskott]

run CMD.... 

[Buck Beach]

ORIGINAL: topeverest

If someone has a tutorial on using this, I would love to see it.  I've tried it a few times and not been terribly successful.

tm.asp?m=2317485&mpage=1&key=excel%2Ceditor%EF%BF%BD

[michaelm75au]

ORIGINAL: topeverest

In the scenario folder...not a GUI

One day when I am not busy ([&:]), I'm going to try to change it to GUI.