Scenario Reinforcements

[Big Ivan]

Development Team,

Is there a way to change the strength point(s) of a scenario reinforcement after the scenario is completed?

Example: You just completed a new scenario design and want to play test it but you want to change some of the reinforcement strengths before testing.
Can you go back into the scenario using Notepad and change the strength of some platoons or batteries that will come on the board as a reinforcement in that scenario?

I know you can go back through the editor and back out the reinforcement, change it and re-introduce it but that can get a bit confusing. Is there a quicker way of doing it by going through Notepad or word using the scenario file?

Thanks
Big Ivan[:)]

[Warhorse]

Exactly, John, open with Notepad, find the down the bottom of the file with the coordinates, and make sure you get the unit right, can compare with the org file same time also in Notepad. In the example-1065 389 2 4 4 100 6 0 0 3 3 3, I believe the 4 in front of the 100 is the strength factor.