[WAD] CAP Fighters are ignoring 'Ignore Plotting course option'

[peacekeeper118]

3 Save files. First one goes.


In 3 CAP Missions set on scenario, All Mission doctrine for 'Ignore Plotting course when attacking' is No.

However, If you check 'Ignore Plotting course when attacking' doctrine status of F-35s at the center of screen,


'Flight 11344' & 'Flight 11342' - These are set as No. (Following doctrine well)

VFA-146 & VMFA-323 - These are set as Yes. (Ignoring doctrine)

[peacekeeper118]

Switched to the Individual View. Even Flight 11344 & 11342 are now shown as 'yes' in 'Ignore Plotting course'

[peacekeeper118]

So I manually tweaked all F-35 which I mentioned above's 'Ignore Plotting course' setting as No. Several A/C's are obeying for orders, but the others are not.



B 972.6

Scenario DB version is 466, but updating to 470 doesn't make any kinds of differences.

[ComDev]

Took a look a the third exe. What happens is that the aircraft are currently executing a BVR attack, and they ensure that missiles are guided to the target.

If you open the scenario in the scenario editor, set WEAPONS HOLD, delete the AMRAAMs, wait for some seconds (depending on what they were doing, what their OODA cycle is, etc etc) until the fighters re-evaluate their status, they will see the engagement is over, turn around, and follow the plotted course.

[peacekeeper118]

So It was meaningless to micro-manage my fighters after they initiated AAM guidance - Thank you!