Sicily 43 Supply Woes...

[marion61]

I'm pretty sure this is a scenario problem, and my question is, how would you fix it so that the other two hexes with air units start getting supplied? Would putting a port in the hexes help them get supplied, or would you need to put a supply point in those hexes also (with the editor)?

The allied side has three hexes like that, and two air groups are in constant reorganization and you can't fly them to Sicily after capturing airbases. I flew most of my air groups off after I captured the bases, but these two won't come out of reorganization, and the PO isn't flying his air groups out either, so those two groups aren't flying, just sitting in Italy.

[Oberst_Klink]

Dump a supply point at each hex; either permanent or via event editor for some time... that should do the trick.

Klink, Oberst

P.S. Don't forget to have a look at my Tutorial '42

[marion61]

Thank you, and I'm avidly following your tutorials. I've played TOAW before, but I'm still learning from your tutorials. Your doing a fine job.[:)]

[Toby42]

Is this a scenario that was included with the game, or one that you made?

[marion61]

It came with the game. I've never actually tried to mess with the editor before.

[Toby42]

It seems as though several scenario's slipped through from III that weren't converted correctly! It's to be expected, there are a lot of them to convert! I'm sure that they will all be corrected in time?

[Oberst_Klink]

It will be, Kamerad Manx!

Klink, Oberst

[marion61]

I went thru the editor manual, and instead of using the event editor I used the deployment menu to place supply points in the hexes that were without supply for both sides, ran the scenario and all the air groups are supplied now. I've zipped the file, and hopefully this works, but this is the first time I've edited a scenario, so keep that in mind if it doesn't work (my disclaimer [;)]). Zip file attached.

[Rosseau]

Thank you. The editor is a wonderful thing.