Auto Contouring Not Working As It's Supposed To

[geozero]

In editor, the idea behind turning off auto contouring was to paint the entire hex the terrain.

Sadly, turning off auto contouring in a new scenario map I am designing does nothing.

[Lobster]

ORIGINAL: geozero

In editor, the idea behind turning off auto contouring was to paint the entire hex the terrain.

Sadly, turning off auto contouring in a new scenario map I am designing does nothing.

TOAW III. Auto contouring on left side, off right side:

[Lobster]

ORIGINAL: geozero

In editor, the idea behind turning off auto contouring was to paint the entire hex the terrain.

Sadly, turning off auto contouring in a new scenario map I am designing does nothing.

TOAW IV Auto contouring on right side, off left side:

[Lobster]

Nothing has changed, just the graphics.

[geozero]

Not seeing that happen on say a town or woods graphics. It doesn't fill up the entire hex. You have to do that manually. I could have sworn auto contouring off used to do that, sadly I don't have TOAW 3 loaded anymore.

[Lobster]

ORIGINAL: geozero

Not seeing that happen on say a town or woods graphics. It doesn't fill up the entire hex. You have to do that manually. I could have sworn auto contouring off used to do that, sadly I don't have TOAW 3 loaded anymore.

With auto contouring off a town or woods will not fill to a hex side. It's just plopped in the middle of the hex. With auto contouring on the graphics will join together if you put it in two adjacent hexes.

[sPzAbt653]

George, here is TOAW III with Auto-Contouring On and OFF.

[Lobster]

I do miss much about TOAWIII. Especially the response time. [:(]