Adding/removing Supply Sources

[carll11]

So, I see this in the manual;


___________________________________________________
Placing Supply Sources
Once all Reinforcements are set, you need to place Supply
Sources.
Select the Place Supply deployment mode.

Click within the Map view to place Supply Points
for the current Force. Switch sides to place the
other Force’s Supply Points. Upon placement (or
upon clicking on an existing Supply Point), the
program will prompt for the Supply Point’s Variable"


_______________________________________

Ok, I am already past placing reinforcements etc. I have in fact just reopened the scenario ed. to the scn....

I am sorry, I dont see a "Place Supply deployment mode" choice anywhere.....would some kind grognard walk em through this please....

[Oberst_Klink]

It's here. You can click through until it shows 'Place Supply'.

Klink, Oberst

[carll11]

Herr Obert, how are you ? I haven't been around CSME for a bit, lost over here on TOAW;)

And thx, I thought I had clicked/scrolled everything there was to click on every menu, I really try and figure stuff out ( see:blunder my way through) to a solution before asking...



So, question, this supply point sill supplies ALL of that sides offices ( whom are in range etc.) not just that unit?

Thx, C11

[Raindem]

That's correct. The unit you happened to be clicked on has no relevance to the supply point being placed. It supplies the entire side.