Request: jump to preset location addition

[Panjack]

Say you set a location (by, say, pressing CTL + 1 if you have a number pad), Pressing 1 will have the map attempt to center on that location. However, if the map is zoomed out it can be hard to see exactly where this location is. This is also true if the location is near the edge of the map so the map can't center on the location.

1. Would it be possible that if you, say, pressed 1 to have "location 1" have its hex borders in, say, black? This would make it easier to see where the location is
2. Would it be possible if you, say, press SHIFT + 1, then not only will be view be centered on location 1 but the location is also selected (as if you had clicked on it)?